1x Raspberry PI 5MP Camera Board Module v2ġ - Follow this link and download 'RASPBIAN JESSIE WITH PIXEL'Ģ -Once downloaded insert your micro SD card into your computer, then follow one of the guides on this page to write the Raspbian Image to your micro SD card.ģ - When the image file has been written to the micro SD card, insert the card into your Raspberry Piġ - Match your female to female jumpers wires to the images below (note: your jumper wires may differ in color).1x Monitor with HDMI port or HDMI to DVI converter.This is what we use here: SanDisk Ultra 32GB microSDHC Card

1x Raspberry Pi 3 (it will also work on the Pi 2).P3 - Software Installation Required Parts P2 - Connect the Pure Breakout board to the Raspberry Pi Pixel greatly simplifies setup time over previous methods. 1x FLIR Lepton® 2.This is an updated guide to get both visible and thermal camera image overlay working on a Raspberry Pi running the new Raspbian Jessie with Pixel OS using our custom pylepton library for the FLIR Lepton.

FLIR's Lepton SDKs ( Behind EULA Wall ).

Dual Low Noise LDO for 2.8V voltage (can be by-passed).

Power Efficient 1.2V core voltage (can be by-passed).25-MHz reference clock (can be by-passed).Low operating power, nominally 150 mW (Output Format: User-selectable 14-bit, 8-bit (AGC applied), or 24-bit RGB (AGC and colorization applied).Radiometric accuracy (35☌ Blackbody) Greater of:.When inserting it into the breakout board be sure to use proper personal grounding, such as a grounding wrist strap, to prevent damage the module. The Radiometric Lepton module is extremely sensitive to electrostatic discharge (ESD). Note: This kit comes in two separate parts and will need to be assembled once received. A few things to consider about this kit: the breakout board will accept a 3-5.5V input and regulate it to what the Lepton® wants, to read an image from the lepton module all you need is an SPI port, and to configure the camera settings you also need an I 2C port, although this is not required.

Meanwhile, each breakout board in these kits provides the socket for the Lepton, on-board power supplies, 25Mhz reference clock (can be by-passed), power efficient 1.2v core voltage (can be by-passed), dual low noise LDO for 2.8V voltage (can be by-passed), 100 mil header for use in a breadboard or wiring to any host system. The Lepton 2.5 can output a factory-calibrated temperature value for all 4800 pixels in a frame irrespective of the camera temperature with an accuracy of +/-5˚C. The Radiometric Lepton® LWIR module included in each Dev Kit acts as a sort of camera and packs a resolution of 80 × 60 active pixels into a camera body that is smaller than a dime and captures infrared radiation input in its nominal response wavelength band (from 8 to 14 microns) and outputs a uniform thermal image.

Lepton 2.5 raspberry pi